← Back to Dayton Audio - 5" Designer Passive Radiator Aluminium - DSA135-PR

Where the figures for DSA135-PR come from

I take every figure from Dayton Audio's own product page or datasheet where I can. This lists where each figure on the DSA135-PR page came from.

  • 14 from Dayton Audio's product page
  • 3 from Dayton Audio's datasheet
  • 1 worked out from Dayton Audio's figures
  • 1 my estimate
  • 2 not yet checked
  • 3 from NB Audio's listing

General

Driver type Passive Radiator NB Audio's listing
Nominal size 5" NB Audio's listing
Series Designer NB Audio's listing

Thiele/Small parameters

Resonant frequency (Fs) 27.9 Hz My earlier listing, not yet checked
Mechanical Q (Qms) 3.7 Maker's product page
Equivalent volume (Vas) 12.2 L Maker's product page
Compliance (Cms) 1.51 mm/N Maker's product page
Moving mass (Mms) 21.5 g Maker's product page
Mechanical resistance (Rms) 1 kg/s Maker's product page
Effective piston area (Sd) 75.4 cm² Maker's product page
Linear excursion (Xmax, one-way) 8 mm Maker's product page
Displacement volume (Vd) 60.32 cm³ Worked out from the maker's figures

Mounting

Overall diameter 135 mm Maker's datasheet
Cutout diameter 111.8 mm Maker's product page
Mounting depth 38.1 mm Maker's product page
Flange thickness (estimate) ≈ 3.3 mm My estimate, from the maker's drawing
Bolt circle diameter 126 mm Maker's datasheet
Mounting holes 4 Maker's product page
Mounting hole diameter 4.5 mm Maker's datasheet
Weight 0.2268 kg Maker's product page
Dimensions 38 Ă— 135 mm Ă˜ My earlier listing, not yet checked

Materials

Cone Aluminium Maker's product page
Surround Rubber Maker's product page
Basket Steel Maker's product page

Not on file: Qts, Re, Le, Bl, Sensitivity. Either the maker doesn't publish it or I haven't found it yet.

What the labels mean

  • Maker's product page: copied from the maker's product page.
  • Maker's datasheet: read off the maker's own datasheet or drawing.
  • Worked out from the maker's figures: Vd = Sd × Xmax, EBP = Fs ÷ Qes.
  • My estimate, from the maker's drawing: measured off the maker's drawing, usually within ±0.3 mm (up to ±0.5). Measure before you cut.
  • My earlier listing, not yet checked: from the listing I had before I started checking figures against makers. Treat it as a guide until it's checked.
  • NB Audio's listing: how I've filed it in the store.

Check them yourself: Dayton Audio DSA135-PR Specification Sheet